Rumble Strips Can Be Done Right!

Rumble strips are those milled lines at the edge of the road designed to alert a drowsy or inattentive driver that they are drifting off the road. It's a safety mechanism designed to save lives. Unfortunately, in many locations when rumble strips are placed on the road they effectively make it impossible to safely cycle along the shoulder of the road. In my tour of Washington State a few years ago I'd often see rumble strips that looked like this:

I've seen worse examples, where the rumble strip covers every inch of the width of the shoulder. But things don't have to be this way.

Rumble strips can be built into a road in a way that lets them serve their warning function and keeps the almost the entire width of the shoulder usable for cyclists. Here is a photo from a section of SR-507, also in Washington State:

The rumble strips on SR-507 are built into the fog and center lines, effectively leaving the full width of the shoulder available to the cyclist. In addition, every dozen feet or so there are gaps in the rumble strips enabling cyclists to move from the shoulder to the traffic lane. Much of the time on a country road like this, the shoulder is the best place to ride, but a cyclist might have to merge into the traffic lane to get ready to make a left turn or to avoid some debris and it's good to see a road design that recognizes the legitimate needs of non-motorized road users.

Rumble strips can be done right. A page at www.rumblestrips.com (yes darn near everything has a page on the internet!) has some good information and documents describing how to implement rumble strips in such a way as to enhance the safety of all road users.

Keep 'em rolling,

Kent "Mountain Turtle" Peterson

Issaquah WA USA